What the Rain Sensor Module Detects and How
The Rain Water Snow Detection Sensor Module uses exposed copper traces on a PCB to detect water droplets. When rain or melted snow bridges those traces, conductivity increases, and the on-board LM393 comparator switches its digital output from HIGH to LOW. This gives you a clean on/off signal that your Arduino can read instantly.
Because the sensing pad is separate from the control board (connected by a header), you can mount the pad outdoors while keeping the electronics sheltered. That separation alone solves a common problem in weather station builds where moisture creeps into connectors.
Module Specifications That Shape Your Setup
- Rain Water Snow Detection Sensor Module Weather Station: Supply voltage: 3.3V–5V You can power the module directly from an Arduino’s 5V or 3.3V pin — no extra regulator needed.

Rain Water Snow Detection Sensor Module Weather Station - Rain Water Snow Detection Sensor Module Weather Station: Digital output (DO) — active low when rain detected, LM393 The digital pin goes LOW when wet, so your sketch reads a LOW signal as rain. Plan your logic accordingly.
- Rain Water Snow Detection Sensor Module Weather Station: Analogue output (AO) — proportional wetness level The analogue pin gives you a voltage that rises with conductivity, letting you gauge how heavy the rain is rather than just a binary yes/no.
- Rain Water Snow Detection Sensor Module Weather Station: Adjustable sensitivity — onboard potentiometer You can dial in the threshold to avoid false triggers from mist or condensation without changing your code.
Wiring the Module to Your Arduino
Connect the control board to your Arduino using the following pins. The exact pin numbers depend on your board model, but the logic is the same.
- Power (VCC): Connect to Arduino 5V or 3.3V. The module accepts 3.3V–5V, so either works.
- Ground (GND): Connect to any Arduino ground pin.
- Digital Output (DO): Connect to a digital input pin on your Arduino. This pin will read LOW when water is detected.
- Analogue Output (AO): Connect to an analogue input pin if you want a proportional wetness reading. Leave unconnected if you only need a rain/no-rain signal.
Choosing Between Digital and Analogue Output
For most weather station rain triggers — closing a greenhouse vent, activating a wiper, or sending an alert — the digital output is all you need. It gives a clean on/off state that your sketch can act on with a simple if/else.
If you want to log rainfall intensity or detect drizzle versus a downpour, use the analogue output. The voltage increases with wetness, so you can set multiple thresholds in your code. Keep in mind that the analogue value is relative; calibrating it to a specific mm/h rate would require a known reference you supply yourself.
Adjusting Sensitivity with the Potentiometer
The onboard potentiometer lets you set how much water triggers the digital output. Turn it clockwise to require more water (less sensitive) or counterclockwise to trigger on smaller droplets. This is useful for ignoring light mist or condensation while still catching actual rain.
A practical approach: power the module, drip water onto the sensing pad, and adjust the pot until the digital output switches at the wetness level you want. No code changes needed.
What the Supplied Information Does Not Cover
The catalog does not include sample Arduino sketches, specific pin assignments for every board variant, or instructions for mounting the sensing pad outdoors. You will need to write your own read routine for the digital or analogue pin and provide your own weatherproof enclosure for the pad if it will be exposed to the elements long-term.
The module detects conductive water — it will not distinguish between rain, tap water, or salt spray. In coastal or polluted environments, false readings from condensation or residue are possible and may require periodic cleaning of the copper traces.


