Arduino Nano Shield Expansion Breakout Board Screw Terminal

Arduino Nano Expansion Breakout Board with Screw Terminals

This Nano breakout board seats an Arduino Nano V3.0 via two header sockets and exposes every pin to screw terminal blocks — no soldering required to connect sensors, motors, or actuators. Each digital, analogue, and power pin gets its own screw terminal, and a second set of VCC and GND terminals runs down both sides of the board for distributing power to multiple peripherals without a breadboard.

• Screw terminals on every pin — wire sensors and loads without soldering
• Accepts Arduino Nano V3.0 — plugs into the onboard header sockets
• Dual power rails — VCC and GND terminals on both sides
• No soldering required — breadboard-free installation
• Suitable for permanent installations — screw terminal connections withstand vibration

Does the Nano need to be soldered to this board?

No. The Nano plugs into the two 15-pin female header sockets on the board. It can be removed and reprogrammed on a normal breadboard, then reseated. The screw terminals connect to the Nano’s pins through the header sockets when the Nano is seated.

Best for

Permanent Nano installations in enclosures, sensor wiring without a breadboard, workshop automation controllers, IoT node builds, relay switching panels, and any Nano project that needs reliable screw-terminal connections rather than dupont cable push-fits.

Why Kunkune

Shipped from UK stock. 60-day returns, no minimum order. Fast Royal Mail delivery.

Seats an Arduino Nano V3.0, available separately.

Buying in bulk? For orders of 10+ units, contact us for trade pricing.