듀얼 USB 충전 보드로 USB 보조배터리 만드는 법

By Kunkune | Published: 2026-10-28

Category: 사용 방법 가이드

18650 배터리와 Type-C 입력이 있는 듀얼 USB 충전 보드를 사용해 DIY USB 보조배터리를 조립하는 방법을 알아보세요. 안전 점검 사항과 피해야 할 일반적인 실수도 포함되어 있습니다.

Quick answer

To build a reliable DIY USB power bank, pair a protected 18650 battery with a dual USB charging board that supports Type-C input, and follow a simple wiring sequence to avoid shorts and polarity mistakes.

Why the charging board matters more than the battery

The charging board is the brain of your power bank. It handles charging from USB input, boosts the battery voltage to 5V for output, and provides overcharge, over-discharge, and short-circuit protection. A board like the Dual USB Charging Board Type-C 5V 2.4A 18650 Battery Power Bank with Protection integrates these functions, so you don't need a separate protection circuit.

The dual USB output lets you charge two devices at once, but remember that total output is limited to 2.4A. If you connect a tablet and a phone, they will share that current, so charging may be slower than with a wall adapter.

One trade-off: this board is designed for a single 18650 cell. If you want more capacity, you would need a different board that supports parallel cells. Stick with one cell for simplicity and safety.

Build steps

Gather your components: You'll need a Dual USB Charging Board Type-C 5V 2.4A, a single protected 18650 battery, a battery holder or soldering wires, a USB cable for charging, and a multimeter for testing. Make sure the battery has a protection circuit built-in, because the board's protection is not a substitute for cell-level protection. Check that your 18650 is protected and has a capacity that matches your needs.
Connect the battery to the board: Solder or connect the battery's positive terminal to the B+ pad and the negative terminal to the B- pad on the board. Double-check the polarity before soldering: reversing it can damage the board or the battery. Use short, thick wires to minimize resistance. Confirm polarity with a multimeter before applying power.
Test the output before final assembly: Plug a USB cable into one of the output ports and connect a phone or a USB multimeter. The board should provide 5V and start charging. If there's no output, check the battery voltage and connections. A common mistake is a cold solder joint or a loose wire. If output is missing, reflow the solder joints and recheck polarity.
Charge the power bank via Type-C or Micro USB: Use a USB charger (phone adapter or PC port) to charge the power bank through the Type-C or Micro USB input. The board will manage the charging current and stop when the battery is full. Avoid using a fast charger that exceeds the board's input rating, as it may not charge faster and could stress the board. Use a standard 5V charger for best compatibility.
Enclose the build safely: Place the battery and board inside a non-conductive enclosure or use heat-shrink tubing around the board. Make sure no exposed metal parts can short against the battery terminals. Leave ventilation if you expect heavy use, and secure wires so they don't rub against sharp edges. Do a final visual inspection for exposed solder or loose wires.

Product facts

Dual USB Charging Board Type-C 5V 2.4A 18650 Battery Power Bank with Protection: Dual USB Type-C Micro USB 5V 2.4A 18650 Battery Charging Board Mobile Power Bank This board gives you both Type-C and Micro USB input options, so you can charge your power bank with the cable you already have, and its dual USB outputs let you power two devices at once.
Dual USB Charging Board Type-C 5V 2.4A 18650 Battery Power Bank with Protection